Prophi 6R
The controller is designed to be incorporated into the front panel of a PFC-cabinet. It requires a switchboard section of 138 x 138 mm to DIN 43700/ IEC 61554. The controller is inserted from the front and is attached by means of the appended clamps. It may be inserted only by qualified technicians and must be operated in accordance with the specified safety regulations.
Before the Prophi-6R is connected up, all leads and cables must be checked to ensure that no current is flowing through them and the current converter must be short-circuited. Care should be taken to ensure that the measuring voltage and current are in the correct phase position. The measuring-current circuit must be wired with copper leads of 2 2.5mm . The connection should be set up as shown in Fig. 3. The specified safety regulations must be observed
- Operating Voltage 110…230V +/- 15%
- Power Factor Controller for panel door mounting
- Voltage 30-525V, L-N/L-L, 50/60 Hz